|
|
|
|
Joined: Nov 2006
Posts: 850
Member
|
|
Member
Joined: Nov 2006
Posts: 850 |
Hi, Need a little help. is there a tool so you can pull square off of any plane in Sketchup? I know I can do some trig and figure it out but I don't have my construction master.  I am trying to set a rafters plumb face dimension and I just want to pull square off of the roof surface a set dimension. Thanks.
|
|
|
|
|
Joined: Nov 2003
Posts: 1,124
Member
|
|
Member
Joined: Nov 2003
Posts: 1,124 |
when all else fails, use the line tool(um, and the eraser....).
Last edited by Mark Davidson; 03/13/08 10:57 PM. Reason: balance
|
|
|
|
|
Joined: Nov 2006
Posts: 850
Member
|
|
Member
Joined: Nov 2006
Posts: 850 |
Thank you for the reply... Guess I worded the question wrong. I was trying to develop my rafter off of a single line representation already pitched and in the plumb plane. Just to see how pieces and planes met up. It seems to want to follow one of the axis.
|
|
|
|
|
Joined: Apr 2002
Posts: 895
Member
|
|
Member
Joined: Apr 2002
Posts: 895 |
Not sure exactly what you're asking, Mo, but to get a line perpendicular to an existing line, you can use the protractor tool to create construction line. Actually, any angle, not just perpendicular. You can even specify a roof pitch by typing "6:12" for example, into the vcb. CB.
--
Clark Bremer
Minneapolis
Proud Member of the TFG
|
|
|
|
|
Joined: Feb 2007
Posts: 56
Member
|
|
Member
Joined: Feb 2007
Posts: 56 |
Mo
I'm not aware of a tool to do this, but whe you draw it's supposed to tell you when you are square to the line you are drawinf off. (I'm sure you know that!!)
When I'm trying to draw a line, and the computer is sticking to another axis(instead of square to my line), I scroll the view around and zoom in to get it to understand me.
Carlos
Last edited by CarlosCabanas; 04/13/08 02:42 PM.
I cut it twice, and it's still too short!!
|
|
|
|
|
|
|
