Thanks guys. That’s the type of input I was looking for.
The architect and general contractor have identified that the pool will have a cover and a HVAC system/dehumidifier will be provided. My concern is that designing an appropriately sized system may be a challenge and that the timber will be exposed to higher moisture levels than typical. I’d like to be able to provide a frame that can accommodate these potentially higher moisture levels. We usually seal/wax our tenons and we’ll make sure all the end grain is sealed and the posts will not be in direct contact with any concrete.
I’ve looked at some of the sealers/stains that are available for log homes. The concern regarding ‘trapping moisture in’ by applying a sealer is a good point and I plan to contact the sealer/stain manufactures to get additional input.
I realize that you can always come up with inventive ways to handle larger pieces, there is a very nice thread on ‘going it alone’. My guess is I’d need an 8x10, or larger, piece 30’ long. Based on the way we work and the material we typically deal with, I know my guys would have a stroke if I told them we were going to work with 8x10x30 white oak. We do work with larger pieces, I just think the 30’ oak piece is beyond our capabilities.
Chris,
What type of material did you use for the pool enclosure(s) that you have been involved in?
Raphael,
I’m located in North Stonington, CT.
Any other thoughts would be appreciated.
Thanks,
Pete
