Hi,
Have recently downloaded timbercad, read frame manual and installed it over the top of autocad 2006 and thought it was working o.k. Have tried to draw a profile by typing in the command and although I thought i'd set the bpw to bent mode along the yz axis the resulting profile comes out in plan, and has done so for the last 2.5 hours! Am I doing something wrong? Whenever I check which mode I'm in it says the drawing is in plan - I can't seem to lock it into a plane.
Also, after installing it I have the pull down menu but not the side screen menu and the pull down menu is missing the reset bpw command- don't know if this has anything to do with it?
Any help would be appreciated.
Regards
Mark.