|
red oak timber end splits
#524
07/19/03 07:10 PM
|
Joined: Jul 2003
Posts: 7
gpalmer
OP
Member
|
OP
Member
Joined: Jul 2003
Posts: 7 |
I recently aquired a lot of red oak which was cleared in my neighborhood. Unfortunately I did not get to the felled trees quickly enough and they were out in the sun for some time, without the ends being sealed. They are now in timber form and a few of them have splits extending up into the timber 12 inches or so. In particular the timbers which I had sawn up for summer beams are the ones which are split. I am wondering how wise it would be to use the already end split timbers for this load bearing beam. gpalmer
|
|
|
Re: red oak timber end splits
#525
07/21/03 01:04 PM
|
Joined: Mar 2002
Posts: 1,688
Jim Rogers
Member
|
Member
Joined: Mar 2002
Posts: 1,688 |
The split you describe could be more than just a drying split, it could be a split caused by the felling method/procedure. Can you see if it is inline with the felling cuts? I would also question whether or not you should use this as a summer beam. To prevent further splits, hopefully you've treated the ends with a sealant? Jim
Whatever you do, have fun doing it!
|
|
|
Re: red oak timber end splits
#526
07/21/03 04:39 PM
|
Joined: Jul 2003
Posts: 7
gpalmer
OP
Member
|
OP
Member
Joined: Jul 2003
Posts: 7 |
The split dosn't seem to corespond to the felling cuts. The timber looks as if it is seperated into two pieces though, by 3/16" at the end. Perhaps I should just cut a couple feet off and make it a narrower bay. If it was caused by improper felling (I don't know how it was done) does that make the timber unsafe for use? thanks, gpalmer
|
|
|
Re: red oak timber end splits
#527
07/22/03 07:53 AM
|
Joined: Apr 1999
Posts: 21
Mark L Surnoskie
Member
|
Member
Joined: Apr 1999
Posts: 21 |
Consider using splines for the joinery and you may not have to shorten the bay by much. Mark
Mark Surnoskie TIMBERWOLFTREE Pembroke, ON K8A 7P4 613-732-0233
|
|
|
Re: red oak timber end splits
#528
07/23/03 01:08 PM
|
Joined: Mar 2002
Posts: 1,688
Jim Rogers
Member
|
Member
Joined: Mar 2002
Posts: 1,688 |
A split caused by a felling cut is a serious split in the timber. It could affect the strength of the timber. I'm not expert on how to determine if this timber is ok to use or not, but I would question it and try to compensate for it, maybe with a spline joint as mentioned. Good luck, Jim
Whatever you do, have fun doing it!
|
|
|
|
|
|
|