Dave,
I have the LN Scrub, Low angle block & the 10 1/2 Rabbet. The Smoothing plane is next on the list. I used the rabbet plane on every tennon for my addition. If the grain would wander to close to the line when splitting out the waste I would use the Scrub plane to quickly rough it out then a smoothing plane or slick then the Rabbet plane.

All of the LN planes are a pure joy to use! They are not cheep but well worth the money if you are going use them a lot.

Does any body else out there use a Scrub plane? I love this tool!