Hi everyone:

This is alittle off my usual topic, but I am helping install an expensive bannister in a new home which has wrought iron spindles that need to be installed down the stairway.

The steps are enclosed so the spindles and the railing will sit upon the wall which decends along side the stairs.

My question which I am putting out to you is this:

I have to bore percisely on an angle a series of 5 eights inch holes to accept the bottoms of the square spindles. These holes will be on top of an ash board and centred, with nosings on both edges.

What kind of jig would be acceptable for this job--please describe I would really appreciate it.

NH