A question regarding the peg holes. Looking through the code I see that the peg holes are fixed at 1" diameter (Specified in the code as 0.5 radius). I can hack this fairly easily to change the peg size on my computer, although I've not looked to see what effect it will have on the pegs when they are drawn, but I was wondering how much grief it would be to allow this to be user specified in the configure box. I'm up against a deadline at the minute and unlikely to be able to look at it for a few weeks, but if it's too low on the priorities list, I can take a look later on and see if I can figure it out. Do you have a system for receiving patches? If I were to send a diff of the relevant file, would that be enough?