Before you go Jay, I need to clarify my position on universal parts of a frame fitting in various location. It is hard for me to put a piece from one part of the frame that had an intended spot and simply just put it some place else in the frame. Although some pieces are able to be put in any slot, like braces and some girts. Even top plates can we switched, depending on bent spacing and the like. The hard part for me, I realized today as I was sorting pieces of a frame we are raising, is in the layout. When I put a bunch of pieces out on the bunks for cutting they have to be in order, logical order. 1-6 all south side post. They get marked with crayon and race knife as a final marking. It simply goes against my system to mix things up. This orientation that starts in the shop and continues until the thing stands.