Hi
I have some concern about a joint where three beams converge on a post in the same plane. I've seen this joint executed before, and have accomplished the same results myself using through splines and timberlinx fasteners. However, I would like to try it with tennons and pegs only. The bents are pine, principal rafters w/purlins, queen posts,collar ties. My concern is where the tie beam and lower joists join the vertical 8x8 posts. Although I know there is little outward thrust from the rafters because of the queen post collar tie configuration I am nervous about it because of the way things are "supposed" to be pushing. the tie beams are 8x12 and the girts are 6x10 all supporting a second floor. Any thoughts on the cutting of this joint would be greatly appreciated. Thanks in advance
Mike