Hi Curtis and anyone else willing to stick their neck out. Since I have somehow managed to find myself grouped among experts I thought I better ask this question before it pops up in my own forum! *g*

I have been hearing of situations where twisting and drying of the timber frame has
caused panel movement, resulting in air infiltration at panel joints. I understand
that a silicon caulk which is less rigid than foam, has begun to be spec'd by manufacturers. Is this to compensate for the movement and is it permanent? My concern is
migration of moisture laden air through the panel seams will result in condensation
in the panel, resulting ultimately in rot and delamination of OSB and panel.

Is it possible that a membrane or gasket such as bituthane be applied to the joints
to further seal these joints? If so it would seem more effective to apply it over the seams on the exterior of the panel, since a twisting timber could conceivably pull the gasket away from the seam?

It seems that such a solution will also reduce moisture under the roofing, reinforcing the arguments against cold roof requirements.

Thanks