Does anyone know of a tool that can be used to set a point for drawboring. Instead of creating a point on the tenon that is centered in the peg hole and then going back and drilling a fraction closer to the shoulder from that centered point, is there anything that saves steps? It seems a cylinder the size of your peg hole with some sort of offset spring-loaded pin would work. Then you would not have to be so careful as to not set the original point too deep. The outside of the cylinder could have some marking on it that shows the radius of center to pin to edge. Then you could go around and just whack the pin and come back and drill.

Anyone know of a tool for this or something along the same lines?