Hello all,

I am looking for advice on timber shake. I am using kiln-dried eastern white pine, and it seems a lot of what I get from the sawmill shows signs of shake. Everything I read says shake is a defect and should be rejected, but that would mean I would be rejecting at least half of what I get from the sawmill.

The timbers that show sign of shake usually show signs on one end of the timber and maybe in a different location on the other end. I have cut into a few of them and had some of the mortise feel like it was peeling away like an onion.

The first picture shows a king post I was working on and had the shake at the top. When I tried to test fit it to the rafter, the crack formed. The fit was tight but nothing crazy.

The second shows a strut I was cutting, and had this complete ring shake in an area that would be a tenon which would have pegs driven through it. It's close to the pith so I'm not sure it it's cause for concern or not.

This project if for a small cabin, so obviously I want everything to be structurally sound. Any advice that framers could give on these, as well as evaluating shake in the future would be greatly appreciated. Thanks!
Attachments
2.jpg (69.84 KB, 3 downloads)
1.jpg (229.27 KB, 3 downloads)
3.jpg (240.96 KB, 2 downloads)
4.jpg (273.81 KB, 2 downloads)